assembly and a dash number identifying ratio, differential, and end yoke options, is needed to properly identify a Spicer Axle. NOTE It is recommended that when referring to the axle, the complete part number and build date be obtained. To do this, it may be necessary to wipe or scrape off dirt, etc., from the axle housing.
axle shaft. Install the flange plate to the flange Of the axle shaft. Install bolts into flange plate. Slide forcing plate over the axle shaft. Install the adapters so they seat under the cup rib ring. Gradually tighten the bolts until they are located in the dimples on the backside Of the forcing plate. Tools: Flange Plate. esp-5017 Adap-
Install small carrier cap – align holes, make sure it slides into locking side gear smoothly. NOTE: Make sure this cap sits flush with all 8 cams – if cap is not flush, it could cause severe damage to the carrier. Torque 5/16 bolts to 25 FT LBS. Note: when tightening, tighten the bolts in the following pattern: 1 – 5 – 7 – 3 – 8 – 4 – 6 – 2. 6.
Helpful hints for newbies doing Dana 60 gear setup - irate4x4
May 20, 2020 · For the carrier, you want to grind the inside of the bearings so they slide on/off the carrier. For the pinion, it depends upon where the inside shims are. Reading gear pattern - this is painting ring gear and reading pattern. Adjusting pinion …
Place the ARB Differential Cover in position on the differential housing to ensure adequate clearance to surrounding components. NOTE : Checking for clearance between diff cover and all internal parts is crucial before tightening the cover bolts. Failure to do this may cause damage to your differential.
Dana 60 torque specs for cap girdle with cover.
Aug 4, 2010 · Apply silicone to the cover instead of a gasket to limit cover deflection. Install the cover and torque mounting bolts to 30 ft/lbs. Torque the bearing cap load bolts 10 ft/lbs. Do not over-tighten the bolts or bearing distortion will occur.
Dana 60 Gear Installation - Strange Engineering
Strange axles are available for Dana 60, Ford 8.8-inch and Ford 9-inch, GM 10 and 12-bolt, ’57 to ’64 Oldsmobile, and Mopar 8.75-inch rear end configurations. Strange axles are recommended for use in positive traction, limited slip, and Detroit Locker style rear ends.
This B&M Cast Aluminum Differential Cover has been designed to work on most vehicles equipped with a Dana 60 or 70 axle. This differential cover provides several advantages over factory covers. The extra capacity provides increased oil volume and added cooling, while the thick aluminum construction increases case rigidity.
Dana 60 Questions - Pirate 4x4
Apr 26, 2009 · With torque still applied, tighten the lower balljoint nut to 70-90 ft-lbs. If the bottom stud should turn with the nut, add more torque to the forcing screw. Remove the puller, step plate and holding plate.
Technical Specifications - Down To Fab
Need to find torque specifications for your Dana 60 ring gear bearing cap bolts? How about axle carrier gear ratio breaks? What parts and pieces can interchange or be made to fit other applications? This is the section for you. Bear with us, this is …